Tray Cable

*Product images are for illustrative purposes only and may differ from the actual product.

SDN - Small Diameter Neoprene - 14 AWG

Small Diameter Control
SDN - UL Type TC
90°C - 600 Volt

Construction
Category Conductor Description Bare, soft annealed copper per ASTM B-3 14 AWG (19 strand)
Category Insulation Description Each conductor is concentrically insulated with a 15 mil wall of high dielectric flame retardant polymer (HDPE) with 5 mil wall of clear polymide (nylon) jacket extruded over primary insulation and conforming to UL requirements
  • To be installed in trays, raceways, troughs, channels, ducts, conduit, and by direct burial.
  • Recommended for wet or dry locations and outdoors in cable trays where a sunlight resistant rating is required.
  • Designed for control, power, lighting, telemetering, signal, relay traffic control, wherever flexible, small diameter cable is required such as cranes, hoists, and some robotics applications.
  • OSHA acceptable
  • Recognized for use in Class 1 or 2, Division 2 hazardous locations
  • UL Type power and control tray cables and Articles 318, 340, 500, and 501 of the NEC
  • Cables pass UL 1277
  • Cables are rated as Type TC, 600 volts, 90°C

Questions & Answers

Ask a Question

Part Number Table

Part # Gauge Conductors Jacket Thickness Outside Diameter Inches Material Weight (Lbs./M')
AS11402 14 2 0.045 0.325 78
AS11403 14 3 0.045 0.34 89
AS11404 14 4 0.045 0.37 106
AS11405 14 5 0.045 0.4 133
AS11406 14 6 0.045 0.435 142
AS11407 14 7 0.045 0.47 165
AS11408 14 8 0.045 0.505 185
AS11409 14 9 0.06 0.58 235
AS11410 14 10 0.06 0.58 268
AS11411 14 11 0.06 0.605 270
AS11412 14 12 0.06 0.595 311
AS11413 14 13 0.06 0.635 305
AS11414 14 14 0.06 0.635 325
AS11415 14 15 0.06 0.665 340
AS11416 14 16 0.06 0.655 390
AS11417 14 17 0.06 0.725 400
AS11418 14 18 0.06 0.725 410
AS11419 14 19 0.06 0.725 430
AS11421 14 21 0.06 0.74 470
AS11424 14 24 0.06 0.805 593
AS11425 14 25 0.08 0.875 520
AS11430 14 30 0.08 0.905 660
AS11437 14 37 0.08 0.99 920

Note: The data shown are approximate and subject to standard industry and manufacturer tolerances.